WINCH MOTOR CONTROLLER
 ASSEMBLY 199-01-MA
   SPECIFICATIONS

MECHANICAL
         Size            30.5 Long x 20.3 High x 7.8 Thick cm
                           12 x 8 x 3 inches
         Mounting    Free standing on four rubber feet

ELECTRICAL
    SUPPLY
          NOTE THIS UNIT SHOULD ONLY BE USED WITH A PROPERLY GROUNDED
           ELECTRICAL OUTLET. CONSULT A LOCAL ELECTRICIAN IF YOU ARE
           NOT POSITIVE THAT THE OUTLET YOU ARE USING IS WIRED
           PROPERLY.
           Voltage - 120 Volts AC 60 Hz (220 Volts AC Available on special order)
           Current - 0.1 Amp internal + motor current (maximum 15 Amps)
           Circuit protection - Fuse provided only for internal circuitry.
                              Bussmann # MDL-1/2, 1/2 Amp 250V Slow blow
                           - No overcurrent protection is provided for
                              the motor. This must be provided for by
                              the user as recommended by the manufacturer
                              of the motor and in accordance with your
                              local electrical codes.

     MOTOR
        Type - Electrically reversing motors which have separate run and
             start windings.
        Size - 1 HP (120 Volts) Maximum (2 HP 220 V)
        Circuit protection - None. Motor overload protection must be
             provided for by the user as recommended by the manufacturer
             of the motor and in accordance with your local electrical
             codes.

   CONNECTORS
        SUPPLY - Standard 120V 15A U ground male plug on 5 ft of three
             conductor 14 gauge SO rated rubber jacketed cable.
             MATING CONNECTOR - Standard duplex receptacle with U ground.
        MOTOR - Hubble #2510A, female twist-lock 5 conductor including
             ground rated at 20A 120/240V AC 3 phase.
             MATING CONNECTOR - Hubble #2511.
        RADIO CONTROL - Preh #71222-070, 7 conductor female DIN Standard.
             MATING CONNECTOR - Preh # 76597-670 or Equiv.
        CONTROL - Electrovert #8213S/12W-OB, Male socket for a pluggable
             screw type terminal strip 12 conductor which is supplied
             with the controller.
             MATING CONNECTOR - Electrovert # 8213B/12-OB (one is sup-
             plied with the controller). Pluggable terminal strip with
             screw type contacts. Accepts wire gauges up to 12AWG.

           SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTIFICATION

RETURN TO HOME PAGE